Tech Tip: After integrating Spectrum with CAPC some models do not come over when the Spectrum data source synchs

Document created by Joe_R Employee on Aug 24, 2014Last modified by SamCreek on Dec 17, 2016
Version 3Show Document
  • View in full screen mode

Issue:


After integrating Spectrum with CAPC some models do not come over when the Spectrum data source synchs.  When turning on debug in Spectrum for Performance Center Integration and Performance Center Integration Synch, the following message is seen in the Spectrum tomcat log (catalina.out or stdout.log)

 

Aug 11, 2014 8:40:10 AM (http-bio-8080-***-xx) (NetqosSyncLog) - (TRACE) - Device 0x3019219 is not active yet, added to postponed list for later processing


Answer: 

In Spectrum the MODEL_STATE (0x1007c)  must be set to 1 (Active).  If it is not, it is added to the postponed list for later processing as noted by the message above and the device will not come over with the integration.  To investigate why a model might not be activating you can enable model activation debugging .  mdlact_debug  and review the output in the VNM.OUT

Attachments

    Outcomes