Tech Tips: To change to CA Service Virtualization for Performance mode

Document created by MarcyNunns Employee on Aug 31, 2017
Version 1Show Document
  • View in full screen mode

To change to CA Service Virtualization for Performance mode, perform one of the following actions:

 

In local.properties of where each VSE is running, set lisa.vse.performance.enabled=true

 

Issue the VSEManager command --performance on

 

If you do not enable performance mode, you can only have a concurrent capacity of 1 when you deploy the virtual service and you are limited to 1 transaction every 100 milliseconds, per VSE.

 

This is documented in the "SV Installation and Configuration" section of each DevTest release documentation.

Attachments

    Outcomes