Hi,
I have two same ip. I want to discover on the one landscape. How is it possible. Please share the procedure.
You can use the Secure Domain Manager.
Secure Domain Manager (SDM) - CA Spectrum - 10.1 to 10.1.2 - CA Technologies Documentation https://docops.ca.com/ca-spectrum/10-0/en/managing-network/secure-domain-manager-sdm
Overlapping IP Domains - CA Spectrum - 10.1 to 10.1.2 - CA Technologies Documentation https://docops.ca.com/ca-spectrum/10-0/en/managing-network/secure-domain-manager-sdm/overlapping-ip-domains
Regards,
Tarun
You could try something with NAT as well but fundamentally, it comes down to basic issues at the IP layer: How can you ping/telnet/ssh to two different end points using the same IP address? If you don't do something at the network layer (NAT), then you have to do something at the application layer which in this case is SDM or another SpectroSERVER. Please refer to this:
Managed Service Providers and Overlapping IP addresses.
The 2nd model can be created using 'Create Model By Model Type'. However you will get "Duplicate Model Detected" alarm on both models.
What is the reason behind this requirement?
How to remove duplicate model detect alarm after createmodelbymodel type.... Dont want to see again....
If i delete from alarm. It will be create or not again and again.
Please refer to below KD article
Spectrum not reasserting the DUPLICATE MODEL DETECTED alarm as expected.