DX Unified Infrastructure Management

  • Private Community

  • 1.  Tech Tip: NFA 9.1.2 Severity 1 Defect

    Posted May 02, 2013 06:04 PM

    Notice:

    We have determined there to be a Severity 1 Defect in the DSA loader for NFA 9.1.2.218. This will cause data for interfaces from a router with a flow source IP address of greater than 127.255.255.255 to not load historical data. This applies to 3 tier installations only. If you have already installed NFA 9.1.2.218 or upgraded to NFA 9.1.2.218 with a 3-Tier configuration, please contact CA Support for the solution. If you have not yet installed, the new DSA installer will be posted shortly. If you are using a 2-tier or standalone configuration, please disregard this notice.

    Thank you for your patience -

    CA Support



  • 2.  RE: Tech Tip: NFA 9.1.2 Severity 1 Defect

    Posted May 03, 2013 03:45 PM
    We have tested the new DSA and are in the process of posting it to the portal. Thank you for your patience.

    Best Regards,
    Tony


  • 3.  RE: Tech Tip: NFA 9.1.2 Severity 1 Defect

    Posted May 10, 2013 04:01 PM
    The new DSA is posted and available on support.ca.com via the downloads section:

    CA Network Flow Analysis DSA r9.1 SP2 - Setup (EN, JP, SCH, FR)
    DVD05163411M.iso

    Thank you for your patience!

    - James


  • 4.  RE: Tech Tip: NFA 9.1.2 Severity 1 Defect

    Broadcom Employee
    Posted May 10, 2013 04:17 PM
    FYI, if you already have installed 9.1.2.218 in a distributed environment you should apply the patch at the link below instead of running the new DSA installer mentioned above.

    ftp://ftp.ca.com/pub/netqos/product_patches/NFA/9.1.2/DSALoader_IP.zip

    If you are installing 9.1.2 fresh in a 3 tier environment or upgrading a distributed 3 tier environment from RA 9.0.161 then you should go ahead and use the new DSA installer from the support.ca.com download center mentioned by James in the last post.

    CA Network Flow Analysis DSA r9.1 SP2 - Setup (EN, JP, SCH, FR)
    DVD05163411M.iso