AnsweredAssumed Answered

Configuration Steps to Avoid during APM CE Deployments

Question asked by Hallett_German Employee on Oct 27, 2014

This is an update of an old Tech Note I created

 

Introduction

 

 

This document is the result of a question raised by a customer during an engagement.—what things should I avoid when deploying and using APM CE?

 

 

Guiding Principles

 

 

1. Try to avoid many the conditions presented below through 1) capturing clear requirements, 2) having non-overlapping roles and responsibilities, 3) review suggested configuration settings before deployment, 4) double-check configuration entries and 5) monitor APM logs and defects after deployment.

 

 

2. If having one the conditions listed below, then attempt to resolve and correct as quickly as possible.

 

 

Deployment

 

 

The following are some steps to avoid when deploying APM CE:

 

 

1. For enterprise-wide deployments, not having project managers to coordinate and monitor the deployment.

 

 

2. Having incorrectly architected the location or number of TIMs/Collectors. This is possibly due to incorrect traffic estimates, application scope changes, or other factors.

 

 

3. Roles and Responsibilities issues

 

 

 

a. No one assigned with APM CE responsibilities on an ongoing basis.

 

 

 

b. APM Administrator has no or little training.

 

 

 

c. Overlapping or unclear CEM roles and responsibilities

 

 

 

4. TIM network span or tap issues

 

 

a. Out of sequence packets due to inputs of multiple speeds or multiple input contention. This could impact successful recording and transaction statistics.

 

 

 

b. Tap, span, or aggregator incorrect configured and fails to show HTTP/HTTPS traffic or two way traffic.

 

 

 

 

Configuration

 

 

 

Misconfiguration

Impact

The following are some of the misconfiguration steps that can impact the success of the APM CE deployment:

Web Servers Filters/MTP Hardware Filters

Not seeing correct traffic, inability to record.

Inactive Users

Too low a setting can slow down the Tim with many inactive users. Too high a setting may result in too many active users who should be made inactive.

Licenses

Expired or Invalid license may mean a system failing to run.

User Processing Type

Using enterprise mode when there are too many active users can slow down the TESS-EM and exceed system capabilities.

SMTP Settings

Not getting reports delivered to one or more persons.

Time Zone Settings/Synchronize Time

Incorrect time or gaps in APM CE statistics.

Statistics could also be duplicated or

corrupted. Also problems while recording.

Time on TIM incorrect or not propagated from EM.

User Privileges

CEM Analyst/Administrator cannot access reports and administrative functions due to security settings. This is especially true for EEM.

Monitor

Inability to monitor defects. Two TIMs monitoring the same servers may result in duplicate transactions.

Not enabled will result in no defects and reports be created.

 

 

Credits & Acknowledgements

 

Some of these ideas were culled from the CEM training and official documentation. My thanks to the creators and maintainers of both of these invaluable sources.

 

Outcomes