AnsweredAssumed Answered

Using action.command against alternate robot

Question asked by Hayes on Oct 2, 2015


I have an alarm setup from my netapp probe that alerts me when a lun is over 80% full.  The alarm message looks like this.

 

 

The LUN '/vol/ed_actuate_prd_data/ed_actuate_prd_data{f}.lun' on 'ed-netapp-g' is now 91.15 percent full

 

When I run the action.command, it performs its action against the robot that generated the alert.

 

I need to run the action.command against a different robot. In this case, the robot would be ed-actuate-prd.

 

I will extract that information using my script. I just need the right commands to tell action.command to run against a different robot then the one the alarm was generated from.

 

Thanks

Outcomes