DX Unified Infrastructure Management

  • Private Community

  • 1.  How can i achieve sub interface level access control in UMP

    Posted Jun 20, 2017 02:08 AM
    Hi Guys,
    As a service provider i am having a shared devices and environments monitored by CA Unified Infrastructure Manager (CA UIM).
    I would like to create a Account with respect to individual customer and map the Sub interface / Interface of a switch device.
    Would like to achieve the same in various probs such as VMware, Exchange, Net connect etc..
    Kindly guide us in mapping single parameter to customer.
    Thanks in advance
    With warm Regards.

    Durai Raj D



  • 2.  Re: How can i achieve sub interface level access control in UMP

    Broadcom Employee
    Posted Jun 20, 2017 02:42 AM

    Is this the same question below ?

    How to set Origin to the Interfaces in a Network Device?

     

    What we can do is overriding origin value of Performance data (QoS data) via qos_processor probe, which gives you Data Partitioning.

    What does the qos_processor probe do?



  • 3.  Re: How can i achieve sub interface level access control in UMP

    Posted Jun 20, 2017 03:36 AM

    Dear Yu,

     

    You are correct. We are looking for the solution like that..

    However we are expecting the same in other probs too like VMware, Exchange etc..

     

    Note : As per our earlier conversations, since we can't perform the QOS origin enrichment since our infra is Huge.

     

    Regards

    Durai Raj D