DX NetOps

Hi friends

Anyone know please..

How do i change in device family ?

tks

Valter

Hi,

what exactly are you trying to change? Please specify your question, maybe someone will be able to help you further then. 

Beste Regards

Marco

Hi

Change a family from a device..

ex.

From:Cisco IOS
For: Cisco IOS - SSH Capable

It seems simple but I do not know how..help please

Check this out:

To place a device into the Cisco IOS - SSH Capable family, the following conditions must be met:

·         The device descriptor must indicate a firmware version of 12.2 (18) or greater.

·         The feature set must contain letters "K9" indicating the device has the necessary encryption functionality that is needed for SCP.

·         SSH access for the device must be unblocked at the time of discovery.

Note: If SSH access to the device is blocked (for example, with a firewall) at the time of discovery, put the device in the Cisco IOS device family.

For example, a device with the following description is placed in the Cisco IOS - SSH Capable family:

Cisco IOS Software, 7200 Software (C7200-JK9S-M), Version 12.3(14)T6, RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2006 by Cisco Systems, Inc.Compiled Thu 05-Jan-06 05:36 by dchih

A device with the following description is placed in the Cisco IOS family and is not capable of obtaining configurations using SSH/SCP:

Cisco Internetwork Operating System SoftwareIOS (tm) C2600 Software (C2600-J1S3-M), Version 12.3(17a), RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2005 by cisco Systems, Inc.Compiled Mon 12-Dec-05 1

If it is not in the SSH Capable family then one of the above was not met.

Here is the documentation link:

https://docops.ca.com/display/CASP102/Introduction

Thanks!

Matt

You cannot move manually from one default Device Family to another default Device Family using OneClick Console. Only when the requirements of Cisco IOS - SSH Capable Family (as described by Matthew_Gay above) are met then Reconfiguration -> Reevaluate NCM Device Family will move it accordingly. 

However, if you create your custom Device Family, you can manually add (Add To -> Device Family...) the device into your custom Device Family using OneClick Console.