AnsweredAssumed Answered

SSL Bridging and CA Access gateway/SPS

Question asked by JaimeBritton62352722 on Jul 26, 2017
Latest reply on Jul 27, 2017 by Osarobo_Idehen

We are using CA Access Gateway/SPS with NetScaler as the load balancer. When we set up SSL on the SPS and try to access the HTTPS endpoint via the NetScaler load balanced URL, we are not having success unless we enable SSL bridging/pass-through on NetScaler. One of the errors we received without SSL Bridging enabled is below:


"Your browser sent a request that this server could not understand. Reason: You're speaking plain HTTP to an SSL-enabled server port. Instead use the HTTPS scheme to access this URL."

The above message was received while we were using HTTPS in the browser.


Accessing the HTTPS endpoint and bypassing NetScaler (via host entries) works fine.


Has anyone faced this issue before? Is there anyway to get this to work without SSL bridging?


SPS version: 12.52 SP1 CR04