AnsweredAssumed Answered

In bgp monitoring we donot see active ip4 monitoring options

Question asked by MCX.1 on Mar 14, 2018
Latest reply on Mar 14, 2018 by shunsuke_katakura

We are using ca uim 8.5.1 we have discovered few cisco 2911 models using snmp protocol and we are using snmpcollector. We can see  under bgp peer (from snmp collector) bgp messages incoming, bgpmessages outgoing and few other monitoring parameters but our requirement is to get Activeipv4multicast prefix froom peer, state, route count recived.

 

Is this an issue with mibs at end device or does the end device needs to get certify. Kindly guide on this as this is very critical requirement. 

Outcomes