AutoSys Workload Automation

  • 1.  Email Notifications with AutoSys and Office365

    Posted Apr 12, 2018 05:10 PM

    Has anyone been able to configure email notifications successfully with Office365? 

     

    I have been trying to , but I keep getting this message: 

    [04/12/2018 15:50:33]      CAUAJM_E_20214 Email notification failed for job <job3>. Detail information <Failed sending data to the peer>.

     

    This is what I am using in my config file..

    NotifySMTPHost=smtp.office365.com:587

     

    I was able to test with a postfix relay with the same office365 information, but haven't been able to get it working via AutoSys... 

    Any pointers?



  • 2.  Re: Email Notifications with AutoSys and Office365
    Best Answer

    Posted Apr 16, 2018 01:03 AM

    Hi Deekshit,

    You might have better luck with the "Direct send" method discussed in the following MS article:

    How to set up a multifunction device or application to send email using Office 365 - Office 365 

     

    You basically need the "Point to Address" and Port 25 needed. 

     

    One challenge could be the TLS requirement. I am not sure we support TLS yet. I'll find out and update



  • 3.  RE: Re: Email Notifications with AutoSys and Office365

    Posted Feb 05, 2024 08:49 AM

    Hello Chandru,

    Did you find out TLS requirement? Kindly update. Getting below error.

    [02/05/2024 15:50:33]      CAUAJM_E_20214 Email notification failed for job <job_name>. Detail information <Failed sending data to the peer>.