DX NetOps

HI All,

Could someone please tell us what the statement  is that is necessary to be put into  the Cisco device configuration, that traps to Spectrum so that it will perform an configuration capture after someone logged into the switch and made and saved a configuration change.  We had the info at one time but cant find it.  Also could you tell us the configuration statement for the Juniper as well.

Thanks In Advance.

Here is the traps from the documentation, we just need to know what the corresponding statement is that goes in the configuration to trigger the trap.

Network Configuration Manager supports the following two traps:

■ Cisco: ciscoConfigManEvent 1.3.6.1.4.1.9.9.43.2

■ Juniper: jnxCmCfgChange 1.3.6.1.4.1.2636.4.5

When either of these traps are received, CA Spectrum generates event 0x00821029. This event then triggers Network Configuration Manager to perform a capture. You can map additional configuration change traps to this event if you want to trigger a capture for other supported devices.