DX Unified Infrastructure Management

Hi All,

I see the below from UIM documentation on Dynamic thresholds and bit confused on how to configure.

What are the thresholds value units for each Algorithm listed below and provide me an example for each.

1. Click the Dynamic Alarm check box. The Dynamic Alarm options become available.
2. Choose an Algorithm to use:
   • Scalar - Each threshold is a specific value from the computed baseline.
   • Percent - Each threshold is a specific percentage of the computed baseline.
   • Standard Deviation - Each threshold is a measure of the variation from the computed baseline. A large standard deviation indicates that the data points are far from the computed baseline. A small standard deviation indicates that they are clustered closely around the computed baseline.
3. Choose an operator for the threshold:
   • > An alarm occurs when the metric is greater than the set threshold.
   • > = An alarm occurs when the metric is greater than or equal to the set threshold.
   • < An alarm occurs when the metric is below the set threshold.
   • <  = An alarm occurs when the metric is below or equal to the set threshold.
   • = An alarm occurs when the metric is equal to the set threshold.
   • != An alarm occurs when the metric is not equal to the set threshold

Thank you.

Regards,

Rajashekar

Hi Rajashekar,

Below KBs provide addional information on the algorithms for standard deviation and Percent

• Baseline_engine Standard Deviation Algorithm

https://comm.support.ca.com/kb/baselineengine-standard-deviation-algorithm/kb000013925

•  Baseline_engine percent algorithm calculation

https://comm.support.ca.com/kb/baseline-engine-percent-algorithm-calculation/kb000095012

Thank you Franklin for these KB articles. 

Here is another KB for baseline_engine scalar algorithm calculation 

UIM Tech Tip: Baseline_engine scalar algorithm calculation 

Great. Thank you for this. Unable access the example listed in the above mentioned Tech Tip.

https://ca--c.na60.content.force.com/servlet/rtaImage?eid=ka00c000000ygHk&feoid=00N0c00000B92wB&refid=0EM0c000000GgbY 

Please help me to get this.

Are you able to access below KB .Has same content as Tech tip

UIM baseline_engine scalar algorithm calculation - CA Knowledge 

Yes Franklin. If the content or explanation is same, I am good with this.

Thank you once again.