Clarity

  • Private Community

  • 1.  FTE showing Zero on Capacity vs Demand by resource OOTB jasper report.

    Posted Aug 17, 2018 04:49 PM

    I have run the Capacity vs Demand by Resource, when the filter Unit type is Hours then Capacity and Demand shows some numbers.

     When I pass FTE Capacity and Demand is Zero, how this report works ?



  • 2.  Re: FTE showing Zero on Capacity vs Demand by resource OOTB jasper report.

    Broadcom Employee
    Posted Aug 17, 2018 05:16 PM

    Hi Jaya,


    There is one defect (DE34301) I'm aware of you could be hitting, depending on your PPM version (See: CA PPM: Zeroes are displayed for the Available FTE - CA Knowledge ) This defect is fixed in 15.3 (and 15.2 patch 3).

     

    Regards,

    Kristin Schroer



  • 3.  Re: FTE showing Zero on Capacity vs Demand by resource OOTB jasper report.

    Broadcom Employee
    Posted Aug 17, 2018 05:26 PM

    This defect is not what is problem defined, the defect is for adhoc reports using domain but what is asked is for OOTB reports 

     

    See if you meeting all the pre requisite for the reports documented here Capacity vs. Demand by Resource - CA PPM - 15.4.1 - CA Technologies Documentation 



  • 4.  Re: FTE showing Zero on Capacity vs Demand by resource OOTB jasper report.

    Posted Aug 20, 2018 09:24 AM

    In this Issue case its 15.2 patch 3