DX Unified Infrastructure Management

Hi,

I have created a dashboard and cluster variables don't show in the dashboard.

Does anyone know how I can make them look and when they go to the other node is the same?

For example: In CDM probe i can see all disk:

But in dashboard only view local disk.

Thanks.

Hi Sebastian,

Can you check and see what you have the 'QoS source' set to publish as? The probe

   defaults to using <cluster ip>

Configure Cluster Alarm and QoS Source

Configure Cluster Alarm and QoS Source

The probe automatically detects and displays the list of virtual groups belonging to the cluster.  You can configure the alarm and QoS source for each virtual group as one of the following parameters:

• <cluster ip>: The IP address of the cluster.
• <cluster name>: The name of the cluster.
• <cluster name>.<group name>: A combination of the cluster name and the group name

So in the dashboard you may need to check by the cluster ip or name.

Hopefully this helps.

Regards,

Greg

Hi Greg,

In effect this is the problem, now i can see the Cluster name with his disk. Do you know if is posible to see about each node name?

Thanks.

As I understand it you will have 3 entries
   nodeA - will show local disks

   nodeB - will show local disks

   clustername - will show clustered disks

Yes and i need to see all disks (local and clustered) when nodeA or B is active 

Its posible?