DX NetOps

  • 1.  No Data to display for interfaces

    Posted Feb 20, 2019 10:54 PM

    Hi All,

     

     Getting No data to display for most of the interface .One of the interface type is "Interface Type: propVirtual"  There is any different metric family for this type?



  • 2.  Re: No Data to display for interfaces

    Broadcom Employee
    Posted Feb 21, 2019 07:27 AM

    Hi Praveen:

     

    Not really enough to go on here.  Are you talking about all interfaces in the system, or just on a device?

     

    Joe



  • 3.  Re: No Data to display for interfaces

    Posted Feb 25, 2019 03:33 AM

    Interfaces in firewall .model no is Cisco ASA5510 .



  • 4.  Re: No Data to display for interfaces

    Broadcom Employee
    Posted Mar 01, 2019 06:51 AM

    What version of CAPM is this?  Have you tried stopping polling and then restarting it?

    - Find a problem device under monitored devices

    - Under the details tab click stop polling at the bottom of the page - wait 5 minutes for polling config to clear out

    - Then click start polling - give it 15 minutes - do you now see data?



  • 5.  Re: No Data to display for interfaces

    Posted Mar 12, 2019 11:02 AM

    Its 3.6. 

    I have deleted the device and discovered again now the reports are working fine ,but it is not the solution. Not sure still how devices will occur in future.