ca.portal.admin

Re: [IDMS-L] Turn diagnostics off in batch mode?

Discussion created by ca.portal.admin on Feb 25, 2008
After looking at the manual (amazing what you can learn that way), it
appears that the MODIFY command only works when compiling from source.
Does this match others' experience?

We normally compile from load on production, which is where I want to
use this. Do you think that compiling from source will change any
options other than the ones specified, i.e. diagnostics and symbol
table?
"
IDMS Public Discussion Forum
IDMS-L@LISTSERV.IUASSN.COM
SMTP
IDMS-L@LISTSERV.IUASSN.COM
IDMS-L@LISTSERV.IUASSN.COM
SMTP








Normal

Normal
Re: Turn diagnostics off in batch mode?
"We finally used syntax similar to Chris's below to compile. A decompile
afterwards shows that only the diagnostic and symbol table were changed.
All the other stuff was left alone. So I believe that this is doing
exactly what we want.

Thanks to everyone for your help!

Outcomes