ca.portal.admin

JREPORT=3D8 with Record Type and DBKEY Selection

Discussion created by ca.portal.admin on Aug 6, 2010
I need to run JREPORT=3D8 with BFOR and AFTER image record selection and a =
specific DBKEY selection. The syntax I am using below is not correct for t=
he DBKEY selection, but I have not been able to determine the correct synta=
x. The syntax is accepted by the CULPRIT report, but I am fairly certain i=
t is not correct.

The JREPORTS section in the CA-IDMS/DB Journal Reports manual shows an exam=
ple using field name DBKEY-A, but this field does not exist.

Please, email me the correct syntax if you have it available.

JREPORT=3D8
SELECT ( TYPE EQ 'BFOR' OR TYPE EQ 'AFTR' )
* AND ( DB-KEY EQ 16007102 )

Thank you,

John Collins
SAIC

858-826-3463 =20
"
IDMS 3rd-party providers forum
IDMSVENDOR-L@LISTSERV.IUASSN.COM
SMTP
IDMSVENDOR-L@LISTSERV.IUASSN.COM
IDMSVENDOR-L@LISTSERV.IUASSN.COM
SMTP








Normal

Normal
Re: JREPORT=8 with Record Type and DBKEY Selection
"Hi John,

Whenever I select by DBKEY I use DB-KEY-A EQ X'hexdbkey' where hexdbkey is the 4 byte hex DBKEY value.

Hope this helps

Pete

Outcomes