ca.portal.admin

JREPORT=8 with Record Type and DBKEY Selection

Discussion created by ca.portal.admin on Aug 6, 2010
I need to run JREPORT=8 with BFOR and AFTER image record selection and a specific DBKEY selection. The syntax I am using below is not correct for the DBKEY selection, but I have not been able to determine the correct syntax. The syntax is accepted by the CULPRIT report, but I am fairly certain it is not correct.

The JREPORTS section in the CA-IDMS/DB Journal Reports manual shows an example using field name DBKEY-A, but this field does not exist.

Please, email me the correct syntax if you have it available.

JREPORT=8
SELECT ( TYPE EQ 'BFOR' OR TYPE EQ 'AFTR' )
* AND ( DB-KEY EQ 16007102 )

Thank you,

John Collins
SAIC

858-826-3463
"
IDMS Public Discussion Forum
IDMS-L@LISTSERV.IUASSN.COM
SMTP
IDMS-L@LISTSERV.IUASSN.COM
IDMS-L@LISTSERV.IUASSN.COM
SMTP








Normal

Normal
Re: JREPORT=8 with Record Type and DBKEY Selection
"Pete,

Thank you for the response. The missing parameter I needed was the REC
parameter with the field name to use, and the position and length of the
DBKEY. =20

REC DBKEY-FOUR 49 4
JREPORT=3D8
SELECT WHEN TYPE EQ ( 'BFOR' 'AFTR') AND DBKEY-FOUR EQ
* (X'16007102')

Regards,

John Collins
SAIC

Outcomes