Education & Training
Services & Support
CA Mainframe Workload Automation
to create and rate content, and to follow, bookmark, and share content with other members.
CA 11 install via MSM
Question asked by
on May 10, 2012
on May 11, 2012 by vraybaud
Show 0 Likes
Is it recommended to install CA Datacom into the same CSI as CA11? Pro's/Con's
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
May 11, 2012 1:55 PM
I use MSM quite extensivley and recently upgraded (two monts ago) our CA-11 and CA-Datacom products to the latest versions. I have each product installed in a separate CSI. I like to do this for each new release of a product as it makes it a lot easier to start over, should I decide to change names or if I make a mistake. I haven't found any negatives to this approach. I have 15 CA products that I install/maintain and use this same philosphy with each one. Haven't found a reason to do it any other way.
Show 0 Likes
Retrieving data ...
CA API GW vAPP: IPv6 NAT Support
factory (agt) not found
CA NCM spectrum backup fail
Capture Startup Script needed for Cisco Switch Module
Followup to Spectrum Optimization and Customization Class: Understanding Spectrum Polling before increasing polling load with Watches.