Education & Training
Services & Support
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on May 25, 2012
on Jun 12, 2012 by kirra
Show 0 Likes
I am getting error RWI 00226 while running BO Report via Clarity 12.1.1 for a while and then fixes itself, never had this error running the same report in Webi (InfoView) , has anyone had similar issues
Error RWI 00226.doc
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 3 comments
(Required, will not be published)
May 28, 2012 3:55 PM
Had seen this error in the past but error went away after restarting the WEBI Server from CMC.
As a guess i believe WeBI Server became overloaded due to the number of reasons like disk space, memory or number of reports running at same time.
I had ignored the error thinking our Dev machine is too small to handle the load since there were few testers and developer were working on the machine.
If this problem occurs again then check from CMC that all the WEBI servers are enabled and running.
Show 3 Likes
Jun 11, 2012 6:38 PM
Did Gurjeet's response help you resolve your issue? If so please mark his post as Accepted Solution.
Show 0 Likes
Jun 12, 2012 8:22 AM
I have verified these settings and all seems to be correct . Still have issues intermittently
Show 2 Likes
Retrieving data ...
Task Session ID in PX Policy
UIM monitoring requirement and queries.
PAM: Failed to establish a communications
Host name is showing as IP instead of server name
Details of Columns in CM_COMPUTER_SYSTEM table