cisco_nxos vs. cisco_monitor -- can't query from nxos probe; can query from monitor

Discussion created by brudden1 on Dec 2, 2011
Latest reply on Dec 9, 2011 by brudden1

I have some cisco harware to monitor.  I initially set up account profiles in the cisco_monitor probe for the 2 devices in question.


From the cisco_monitor probe, I can query snmp successfully and create profiles.


I then realized that this was Nexus equipment.  I assume the cisco_monitor probe does not support/have mibs for this harware, as I can't see any metrics on the right-side panel when i click on the device.


Here's the issue -- I went to the cisco_nxos and tried to setup agent profiles using the same snmp settings that I had used in the cisco_monitor probe, and I get a failue when i try to query.


I used the same snmp setup in the snmpget and interface_traffic probes, and I can query successfully from those probes as well.


Basically, cisco_nxos is the only probe that gives me the query failure.  Has anyone else run into issues with the nxos probe?