steve.burt

Failover using Nats

Discussion created by steve.burt on Dec 9, 2009
Latest reply on Dec 22, 2009 by steve.burt
Interesting results in our development environment

2 HUB in 10.1.x.x & 10.2.0.0

10 servers in 10.1 & 10.2
10 servers in 20.1 & 20.2

There is a  FW NAT in place for the 10.20 to NAT to 10.1 & 10.2 respectivly

Yet when I run a failover, the servers in the 10.x.x.x failover but not the  20.x.x.x

ICMP ports are all fine yet no failover

Robot.cfg all point to the Natted Address

Is there anything I have to take into consideration with the  HUB's

Kind Regards

Steve


Outcomes