AnsweredAssumed Answered

UMP secondary

Question asked by Richard_Briceno on Jun 21, 2017
Latest reply on Jun 21, 2017 by Richard_Briceno

Good morning,

 

I am currently installing two UMP servers, a Primary UMP and a secondary UMP.


When this section is configured,
1. Use Raw Configure to modify the <ump_common> section of the wasp configuration to use the following probe addresses:

The ace = / <domain> / <hub> / <robot> / ace
Automated_deployment_engine = / <domain> / <hub> / <robot> / automated_deployment_engine
The discovery_server = / <domain> / <hub> / <robot> / discovery_server
The nas = / <domain> / <hub> / <robot> / nas
service_host = /service_host
sla_engine = /<domain>/<hub>/<robot>/sla_engine

 

2. Add the following keys with addresses as follows:

 

The maintenance_mode = / <domain> / <hub> / <robot> / maintenance_mode
Udm_manager = / <domain> / <hub> / <robot> / udm_manager
Mpse = / <domain> / <hub> / <robot> / mpse

 

The robot that is indicated in the direction, is the robot of the primary UMP or of the Secondary UMP.?

 

Additionally, in the secondary UMP, I am performing the installation of the Unified Report. Should an additional configuration be made on the secondary UMP?

 

Regards,

Richard

Outcomes